Thread Closed 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[LW] [LW11] LightHouse 3 Trim Tab calibration support
08-30-19, 05:08 PM (This post was last modified: 09-02-19 02:44 AM by Louise - Raymarine - Moderator.)
Post: #1
[LW11] LightHouse 3 Trim Tab calibration support
Hello,

as already earlier from different user requested (back to 2014) a calibration application is fundamentally necessary for the use of 3rd part NMEA2K sensor/devices which need to be calibrated. Special if Raymarine does not offer such device like Bennett NMEA2000 Trim Tab indicator kit.

It is a 3 step simple procedure and not a huge program. The responsibility for the calibration results is even not on the Raymarine site as the calibration is just initiated on the MFD and the values are calculated and stored on the 3rd part device.

Cheap MFD's from different manufacturers are supporting this already for a long time and for a high-end quality product like the Axiom series with LightHouse 3 this function should be a "MUST HAVE" to support the function the MFD is offering.

Thank you.
Find all posts by this user
09-02-19, 06:40 AM
Post: #2
RE: [LW11] LightHouse 3 Trim Tab calibration support
Dear lin4fun,

Thank you for your post.

I have submitted your feedback to our product manager who will review this for potential future release.

Many Thanks
Louise
Find all posts by this user
Thread Closed 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)