Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Interfacing an Axiom to a 7 pin transducer
09-25-19, 06:33 AM (This post was last modified: 09-25-19 09:50 AM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] Interfacing an Axiom to a 7 pin transducer
Looking to slowly upgrade my 2003-era electronics. Replacing the RS125/RN300 combo with an Axiom would be pretty straight forward. The Axiom would (for now) be a companion display to my RL80C plotter/radar.

I was thinking about the Axiom with no sonar, and would later add a second Axiom with radar and a basic transducer (I don’t fish so I don’t need any of the high tech sonars). But I just learned I can likely use the transducer currently on my boat, which is connected to a DSM250. It’s a seven pin transducer, but I don’t know which model. It’s at best a dual 200/50kHz transducer with max power 1000W. All the transducers of that era were either 600W or 10000W.

Can I reuse this transducer use a nine pin to seven pin adapter cable to connect directly to the Axiom?

There appear to be several different 9 to 7 pin adapter cables available. Which one would I use?

Thanks,
Steve

-Steve

2003 Sea Ray 400DB
Find all posts by this user
Quote this message in a reply
09-25-19, 09:58 AM (This post was last modified: 09-26-19 08:04 AM by Chuck - Raymarine - Moderator.)
Post: #2
RE: [CA11] Interfacing an Axiom to a 7 pin transducer
Welcome to the Raymarine Forum Steve,

Q. Can I reuse this transducer use a nine pin to seven pin adapter cable to connect directly to the Axiom?
A. Should the currently installed fishfinder transducer have been mated to a DSM250 as you have indicated and should it have been directly (w/o adaptation) mated to the DSM250, then it may simply be adapted (part #A80485) to be mated to the Transducer socket of an Axiom DV 7 MFD.
Find all posts by this user
Quote this message in a reply
09-25-19, 05:28 PM (This post was last modified: 09-26-19 08:04 AM by Chuck - Raymarine - Moderator.)
Post: #3
RE: [CA11] Interfacing an Axiom to a 7 pin transducer
Thanks. After writing the original post I realized that the Axiom I’m considering (12”) doesn’t come in a DV version. RV only. So it looks like the A80489 Adapter Cable is the one for me, just like the thread two prior to this. Lol.

-Steve

2003 Sea Ray 400DB
Find all posts by this user
Quote this message in a reply
09-26-19, 08:04 AM
Post: #4
RE: [CA11] Interfacing an Axiom to a 7 pin transducer
You're welcome.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)