Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA11] Can Axiom Pro Knob/Buttons Control Multiple MFDs?
09-29-19, 08:06 PM (This post was last modified: 10-02-19 08:20 AM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] Can Axiom Pro Knob/Buttons Control Multiple MFDs?
The RMK-10 be networked with Axiom MFD’s on RayNet to control multiple Axiom MFD’s. But the Axiom Pro units have these same controls built in. So, if you were to connect an Axiom Pro and an Axiom via RayNet, could you use the Axiom Pro’s buttons/knob to control BOTH the Axiom Pro and the networked Axiom MFD’s in the same way you could if you networked an RMK-10? That is, could the Axiom Pro’s controls be used to also control the networked Axiom?

-Steve

2003 Sea Ray Sundancer 320
Find all posts by this user
Quote this message in a reply
10-02-19, 08:27 AM (This post was last modified: 10-02-19 08:30 AM by Chuck - Raymarine - Moderator.)
Post: #2
RE: [CA11] Can Axiom Pro Knob/Buttons Control Multiple MFDs?
Welcome back to the Raymarine Forum Steve,

Q. if you were to connect an Axiom Pro and an Axiom via RayNet, could you use the Axiom Pro’s buttons/knob to control BOTH the Axiom Pro and the networked Axiom MFD’s in the same way you could if you networked an RMK-10?
A. Negative. This feature is currently limited to systems featuring a RMK-9 or RMK-10. That said, a feature request will be logged to consider this feature for inclusion within a future LightHouse 3 software update as well as within future MFD designs.

Please click here more information concerning Feature suggestions.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us