Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Raydome digital rd424d to a series
10-11-19, 09:07 PM (This post was last modified: 10-14-19 11:51 AM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] Raydome digital rd424d to a series
I am trying to find the adapter for a raydome rd424d to an a127/128 anyone have a link to the product thanks
Find all posts by this user
Quote this message in a reply
10-14-19, 12:06 PM
Post: #2
RE: [CA11] Raydome digital rd424d to a series
Welcome to the Raymarine Forum Teamsouthbound,

Digital/HD radomes and HD/SuperHD/Magnum open array pedestals are designed to be interfaced to Raymarine systems via a Digital Radar Cable. While currently manufactured Digital Radar Cables feature a RayNet plug to support Ethernet communications with the system, early Digital Radar Cables were manufactured with a RJ45 plug to support such communications. When mating the latter Digital Radar Cables to the Ethernet Network (RayNet) socket of an HS5 RayNet Network Switch, Axiom/Axiom Pro/Axiom XL MFD, or a/c/e/eS/gS-Series MFD the cable's RJ45 Plug will be mated to one of the following:
- an A80247 100mm RayNet (F) to RJ45 (F) Adaptor; or
- an R32142 RJ45 to RJ45 Waterproof Coupler and an an appropriate length of RayNet (F) to RJ45 (M) Cable.
Find all posts by this user
Quote this message in a reply
10-15-19, 08:02 PM
Post: #3
RE: [CA11] Raydome digital rd424d to a series
Thank you for your response . I will get a adapter part number A80247 and connect that from my a series MFD to my radar cable which will then run to my radar dome. Everything should work properly? Thank you.
Find all posts by this user
Quote this message in a reply
10-16-19, 01:39 PM
Post: #4
RE: [CA11] Raydome digital rd424d to a series
Teamsouthbound,

You need to look at the Digital Radar Cable and determine whether it has been terminated with a RJ45 Plug (see photo below). These Digital Radar Cables were first introduced to support use of Digital radomes and HD/SuperHD open arrays with Raymarine's E-Series Classic MFDs, C/E-Series Widescreen MFDs, and G-Series systems. If so, then either of the options which I had previously supplied will work. The second of the two options would be used if the cable needs to be extended to the location of the MFD.

[Image: 300px-Rj45plug-8p8c.png]

Raymarine later introduced Digital Radar Cables featuring a round RayNet (F) plug which is designed to be mated to the Ethernet Network socket of a/c/e/eS/gS-Series MFDs, Axiom/Axiom Pro/Axiom XL MFDs, and the HS5 RayNet Network Switch. Should the Digital Radar Cable which you presently have be terminated with a RayNet (F) plug, then no adaptation should be required to permit a a127/128 MFD to be mated to the Digital Radar Cable.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)