Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] ST60 Wind Speed error
10-17-19, 04:36 PM (This post was last modified: 10-21-19 10:43 AM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] ST60 Wind Speed error
Hello,
I have an ST60 Wind instrument installed on my boat. For some reason the wind speed keeps jumping up to 99. I installed a new wind transducer at the top of the mast but the same thing is happening. However, when I look at the wind speed on the chart plotter, the speed seems to be accurate. Any ideas?
Find all posts by this user
Quote this message in a reply
10-21-19, 10:50 AM
Post: #2
RE: [CA11] ST60 Wind Speed error
Welcome to the Raymarine Forum Ginodelg,

It is recommended that the ST60 Wind Instrument be reset to Factory Default calibration settings and that the transducer then be re-calibrated to address the reported symptom. Details for resetting Factory Default calibration settings may be found on page 33 of the ST60 Wind Instrument Owner's Manual.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 2 Guest(s)