Raymarine forum

Full Version: CAM200 IP loses picture
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
I have a CAM200 and a CAM220 both powered from the same source and the CAM200 (engine room camera) stops displaying on the MFD after about 20 minutes "video signal lost" pops up. If I cycle the power to just that camera it comes back. Why is this happening and how do I fix? The CAM220 works perfectly.
Hello ocgrant,

I would recommend checking the cables and connections to the CAM200. If the issue persists I would recommend sending the unit into our service department to get evaluated.

Reference URL's