Raymarine forum

Full Version: [TG11] Edson Rudder Arm - Linear drive mounting location
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
I am upgrading our EV-100 Raymarine Wheel Pilot installed in a Catalina 320 to an ACU-200 and Type 1 Linear Drive. Edson advised me to check with Raymarine on how far from center of rudder shaft to drill the rudder arm for the tiller pin.

Tom - Raymarine - Moderator

Hello clburti,

You can find the Linear Drive's installation manual here, which will give this and other mounting dimensions.

Regards,
Tom
Thanks, somehow I missed that information while reading the instructions...

Tom - Raymarine - Moderator

No problem, I'm glad you found the answer you were after.

Regards,
Tom
Reference URL's