07-31-18, 11:53 AM
I installed a new EV1/ACU100 autopilot and need to do the initial linearization. I am keeping my existing ST6002 control head, but have an e7 MFD. How do I get this initial setup done through either one?
(08-02-18 12:58 PM)Chuck - Raymarine - Moderator Wrote: [ -> ]As indicated within the Linearization section of Chapter 7.11, a dialog will be displayed upon completion of linearization listing the maximum detected deviation. As indicated, the maximum detected deviation will also be listed within the Pilot Set-up dialog.