+- Raymarine forum (http://forum.raymarine.com)
+-- Forum: Raymarine Forums (/forumdisplay.php?fid=1)
+--- Forum: Product Selection Assistance (/forumdisplay.php?fid=124)
+--- Thread: Help with compatibility upgrading my equipment (/showthread.php?tid=2125)
Pages: 1 2
RE: Help with compatibility upgrading my equipment - AntonioBindi - 01-04-17 08:02 AM
Hey there
Just got my new equipment and am ready to install it.
I have, however, noticed that I may have missed something. Apparently, the ST60 that I intend to retire is the unit serving depth data to the network, as the transducer is connected to it.
I have also learned that the a95 that I got has spare NMEA cables on its power /data cable. It has a few PAIRS of cables that can be connected, but the transducer brings 3 cables to the St60, so I think I'm going in the wrong direction.
Is it possible to connect my legacy transducer straight into the a95? Will I need adaptor cables, or only a itc5 will do the trick?
Thanks!
RE: Help with compatibility upgrading my equipment - Chuck - Raymarine - Moderator - 01-04-17 09:27 AM
Q1: Is it possible to connect my legacy transducer straight into the a95?
A1: No.
Q2: Will I need adaptor cables, or only a itc5 will do the trick?
A2: Should you desire to interface the currently installed instrument depth transducer to your new system, then it may interfaced to the system via any one of the following methods:
- interface the depth transducer to an i40 Depth instrument which in turn has been interfaced to the SeaTalk socket of a SeaTalk to SeaTalkng Converter which has been installed as part of the system's powered and properly terminated SeaTalkng backbone to which the MFD has been interfaced as a spur.
- interface the depth transducer to an i50 Depth instrument which in turn has been interfaced a spur to a powered and properly terminated SeaTalkng backbone to which the MFD has been interfaced as a spur.
- interface the depth transducer an iTC-5 which has been installed as a backbone component within the system's powered and properly terminated SeaTalkng backbone to which an i70S MFID (required for calibration of transducers which have been interfaced to an iTC-5) and the MFD have been interfaced as a spurs.
RE: Help with compatibility upgrading my equipment - AntonioBindi - 01-04-17 09:35 AM
Considering I have also bought the i70s, and don't have neither i40 or, I 50, seems to me that the itc-5 is the way to go.
Thank you again.
RE: Help with compatibility upgrading my equipment - Chuck - Raymarine - Moderator - 01-04-17 10:05 AM
You're welcome.