+- Raymarine forum (http://forum.raymarine.com)
+-- Forum: Raymarine Forums (/forumdisplay.php?fid=1)
+--- Forum: Fishfinders (/forumdisplay.php?fid=25)
+--- Thread: [CA] [CA11] Transducer Cable Damage (/showthread.php?tid=10095)
[CA11] Transducer Cable Damage - Larrysr - 12-10-19 07:57 PM
When pressure washing the boat I damaged the transducer cable and shield wires to the AIRMAR 275 LHW transducer. Will this cause poor reception? Photo of cable attached
RE: [CA11] Transducer Cable Damage - Chuck - Raymarine - Moderator - 12-11-19 12:05 PM
Welcome to the Raymarine Forum Larry,
From the photo, while it appears that the shield has been exposed, it does not appear that any of the cable's leads were damage. Should this be below the waterline, then much care should be taken to utilize a sealant that will be watertight. In this case, it would be recommended that Gemeco, Inc. (Airmar’s US distributor (803 693 0777)) be contacted for advice concerning how to seal the damaged cable sheathing.
RE: [CA11] Transducer Cable Damage - Larrysr - 12-12-19 01:25 PM
Good Morning Chuck,
Thank you for the information. Very helpful. I'll reach out to Gemeco for how to properly seal the cable.
Kindest Regards,
Larry
RE: [CA11] Transducer Cable Damage - Chuck - Raymarine - Moderator - 12-12-19 01:50 PM
You're welcome.