[TG] Seatalk ng to Seatalk hs using Raymarine p/n A06082 - Printable Version +- Raymarine forum (http://forum.raymarine.com) +-- Forum: Raymarine Forums (/forumdisplay.php?fid=1) +--- Forum: Networking / System Integration (/forumdisplay.php?fid=21) +--- Thread: [TG] Seatalk ng to Seatalk hs using Raymarine p/n A06082 (/showthread.php?tid=10239) |
Seatalk ng to Seatalk hs using Raymarine p/n A06082 - bobby.rees - 01-05-20 12:42 PM Raymarine P/N A06082 = Connect Seatalk hs to Seatalk ng ========================================== Will this End Connector on a Spur cable and plugged into a port on HS5 Seatalk hs Network Switch [S/N: A80007045110] Allow a “Route†from my a78 MFD to send the data to my recently installed Raymarine = EV-200 Power Autopilot with Type 1 Hydraulic Drive Unit West Marine = 14842843 Mfg = T70157UPC = 723193774311 On the Seatalk ng backbone What I want to do is to send a “route†from my a78 to the Autopilot on Seatalk ng to the installed ACU-200 & p70R Control Head 1. Can you control the Autopilot from the Software in the Raymarine a78 MFD to the p70R Autopilot Control Unit 2. My Qty (2) a78 MFDs uses Lighthouse II Release 19 Bobby Rees Mobile = 252-362-3813 Email = bobby.rees@suddenlink.net Sun = 01-05-20 @ 12:41 pm RE: Seatalk ng to Seatalk hs using Raymarine p/n A06082 - Tom - Raymarine - Moderator - 01-06-20 05:20 PM Hello Bobby, I've answered the first part of your question in your other post, but yes, you can control an EV pilot from LH2-R19 on a78. Just connect the Master a78 to STNG as described in the other post. Regards, Tom |