Raymarine forum
EV-200 turns to port - Printable Version

+- Raymarine forum (http://forum.raymarine.com)
+-- Forum: Raymarine Forums (/forumdisplay.php?fid=1)
+--- Forum: Autopilots (/forumdisplay.php?fid=23)
+--- Thread: EV-200 turns to port (/showthread.php?tid=1024)



EV-200 turns to port - landingzone - 06-04-16 05:57 PM

My EV-200 was installed on my 270 Amberjack last year. In general, it works very nicely and I use it mainly for trolling for trout and salmon. When I am trolling in "standby", and decide I want to continue in the same direction I am headed, I press "auto". The boat then turns slowly to port about 20 degrees and works its way back to the desired heading and holds there. What causes this, and how do I correct it?


RE: EV-200 turns to port - Chuck - Raymarine - Moderator - 06-08-16 01:00 PM

Welcome to the Raymarine Forum landingzone,

Have you installed a rudder reference transducer with your autopilot? If so, when you turn the wheel, does the rudder bar displayed on the autopilot's control head indicate the correct direction and angle of the outboard/outdrive's thrust?

What versions of software are installed within the autopilot's control head, EV-1 Sensor Core, and ACU-200?


RE: EV-200 turns to port - landingzone - 06-21-16 08:48 AM

S/W vintages are:
ACU 200 V1.10
EVI Sensor Core V1.11
P70R version 2.12
Rudder reference is installed and dash unit indicates correct direction.


RE: EV-200 turns to port - Chuck - Raymarine - Moderator - 06-21-16 11:01 AM

landingzone,

Early versions of Evolution autopilot software were quite sensitive to having very good speed through water data. The software within your Evolution autopilot ACU, EV-1, and p70R are very old and in need of updating. The software within these products is designed to be updated via any of the MFD's listed on the Evolution ACU, EV-1 Sensor Core, and p70R product software update web pages respectively. Alternatively, the software may be updated by a Certified Raymarine Installer or Raymarine’s Product Repair Center.


RE: EV-200 turns to port - landingzone - 06-21-16 02:33 PM

I don't have a MFD connected or own one yet. I guess I will have to have it updated by an authorized representative. I don't want to remove it from the boat but I not sure I can arrange otherwise. Unit was only purchased about 18 mo. ago. Strange the S/W is so old.


RE: EV-200 turns to port - Chuck - Raymarine - Moderator - 06-21-16 03:57 PM

Noted.