+- Raymarine forum (http://forum.raymarine.com)
+-- Forum: Raymarine Forums (/forumdisplay.php?fid=1)
+--- Forum: Multifunction Displays (/forumdisplay.php?fid=120)
+--- Thread: [DG] [DG11] Temperature from Itc5 is not shown in Mfd (/showthread.php?tid=10591)
[DG11] Temperature from Itc5 is not shown in Mfd - JanneHson - 02-22-20 04:55 PM
Airmar Dst triducer sensor (speed, Deep, temp) is tested to be ok, connected to Raymarine Itc5 converter
Led indicators in Itc5 is ok, Itc5 connected with Seatalkng converter terminal to Mfd Axiom Pro S
However only speed and depth i displayed correctly in Mfd Axiom Pro
Only max temperature is displayed in Mfd, not current temperature
Does anyone have any idea ?
/JanneHson
RE: [DG11] Temperature from Itc5 is not shown in Mfd - Derek - Raymarine - Moderator - 02-25-20 06:44 AM
Hi JanneHson
Thankyou for your enquiry,
There should be no issue with this as far as we know, a couple of things to check,
Go into multiple Data Source selection in the AXIOM and select the DST as source of Speed, depth and Temperature - even if it is selected already, make sure that you RESELECT it again to be sure that the itc-5 that is the source for the data.
The other alternative is to measure the resistance across the temperature thermocouple wires, 10k ohm is about 24 degrees Celcius.
Regards
Derek