[CA] [CA11] How to chose the FISHFINDER temperature sensor as the data source? - Printable Version +- Raymarine forum (http://forum.raymarine.com) +-- Forum: Raymarine Forums (/forumdisplay.php?fid=1) +--- Forum: Instruments (/forumdisplay.php?fid=117) +--- Thread: [CA] [CA11] How to chose the FISHFINDER temperature sensor as the data source? (/showthread.php?tid=10648) |
[CA11] How to chose the FISHFINDER temperature sensor as the data source? - andersrho@gmail.com - 02-29-20 06:53 AM My main water temperature source from my DTS800 is showing the wrong temperature. After a year, the temperature started to increase and I calibrated it fairly often. It's now out of range of calibration, and is now showing a water-temp of more than 30C, when it's 13C in the water. The water temperature in the FISHFINDER app seems OK though. But I do not know how to make that the "System Temperature Data Source", which would solve the problem. On my i70s Multifunction Instrument I see the following: Transducers found: - DST800 (which is showing the wrong temp) - iTC-5 In the FISHFINDER app I see the CPT-S transucer. RE: [CA11] How to chose the FISHFINDER temperature sensor as the data source? - Chuck - Raymarine - Moderator - 03-02-20 11:48 AM Welcome to the Raymarine Forum andersrho, Unfortunately, water/sea temperature source cannot be selected. Please click here to view a FAQ addressing water temperature prioritization with Multiple Data Sources. As STng has the highest priority, the only way force the system to utilize water/sea temperature from the fishfinder transducer would be to disconnect the DST800 from the backbone ... or to replace its insert. |