+- Raymarine forum (http://forum.raymarine.com)
+-- Forum: Raymarine Forums (/forumdisplay.php?fid=1)
+--- Forum: Multifunction Displays (/forumdisplay.php?fid=120)
+--- Thread: [TG] [TG11] Axiom - Fuel Remaining shows ---, why? (/showthread.php?tid=10833)
[TG11] Axiom - Fuel Remaining shows ---, why? - DaveInDevon - 03-27-20 11:41 AM
This is a new Axiom 9 installation and the Fuel Remaining shows --- (dashes), why ?
I have set the Total Fuel Capacity to 640 litres
I have set the Fuel Calculation to use PGN 127489 using data from Yacht Devices Engine Gateways (2 x YDES04 from twin KAMD300) on the same N2K network as the Axiom.
I have set 'all tanks' Full
So why doesn't the estimated Fuel remaing show 640 litres ?
On the N2K network there is also a Yacht Devices Voyage Recorder (YDVR04) which is receiving the fuel rate from each engine - so I know that the Engine Gateways are sending the data.
The Axiom also shows a total fuel used of 1.9 litres, so it is getting the fuel rate from the network.
Thanks
RE: Axiom - Fuel Remaining shows ---, why? - DaveInDevon - 05-20-20 12:43 PM
Having now done a trip of 10+ M the fuel remaing shows the correct value. So after initially switching on Fuel Manager a low level of usage (such as 1-2 litres from the engines at low speed) doesn't calculate the Fuel remaining - it takes some subtantive usage for it to get going. This really should be in the guidance for this feature.
Still it's now resolved
RE: [TG11] Axiom - Fuel Remaining shows ---, why? - Tom - Raymarine - Moderator - 05-21-20 10:32 PM
Hello Dave,
Sorry for the delay replying.
The MFDs need to see a certain amount (I thought it was 1 litre but perhaps it's a little higher) in order to start updating the estimated/calculated fuel values. At low fuel burn rates this can indeed take quite a while. I agree that this should probably be made clear in the operation manual. In most cases it's not an issue because burn rates are high-enough that small usage doesn't take long to go through and data appears quickly.
Regards,
Tom