+- Raymarine forum (http://forum.raymarine.com)
+-- Forum: Raymarine Forums (/forumdisplay.php?fid=1)
+--- Forum: Fishfinders (/forumdisplay.php?fid=25)
+--- Thread: [CA] [CA11] Axiom Pro 12 RVX wont recognize Airmar Transducer (/showthread.php?tid=10933)
[CA11] Axiom Pro 12 RVX wont recognize Airmar Transducer - SJfish - 04-11-20 06:24 PM
Hi,
I recently purchased and installed an Axiom Pro 12 RVX. I installed an RV-100 transducer and that is working perfectly.
I also installed an Airmar SS175H-W 1KW Transducer (SKU AIR-SS175C-12-HW-MM). I used the Airmar Raymarine High, High/Wide, and Medium Band 11 Pin Mix N Match Cable (SKU AIR-MMC-11R-HM) to connect the Axiom Pro.
My issue is the Axiom is not recognizing the Airmar transducer. Is this the correct cable to pair this transducer with the Axiom? I have downloaded the latest lighthouse software and done the factory reset.
Thanks
RE: [CA11] Axiom Pro 12 RVX wont recognize Airmar Transducer - Chuck - Raymarine - Moderator - 04-13-20 10:39 AM
Welcome to the Raymarine Forum SJfish,
The subject transducer is designed to support a single CHIRP frequency band (High) rather than two bands. With such transducers are installed without a second single CHIRP frequency band (Medium or Low) transducer, it is necessary to use an A80328 Single Operation Cable.