Raymarine forum
[CA] [CA11] GS165 2020 trip Yamaha 300s interface - Printable Version

+- Raymarine forum (http://forum.raymarine.com)
+-- Forum: Raymarine Forums (/forumdisplay.php?fid=1)
+--- Forum: Multifunction Displays (/forumdisplay.php?fid=120)
+--- Thread: [CA] [CA11] GS165 2020 trip Yamaha 300s interface (/showthread.php?tid=10946)



[CA11] GS165 2020 trip Yamaha 300s interface - Seadub - 04-14-20 12:35 PM

Hey guys so I’m running dual gs165s with trip yamaha 300s. Before the lighthouse 3 update I had all data from the motors displayed on the screen. Now with lighthouse 3 update there is a Yamaha page that’s on the home screen. It will show data except for the command link data. If I go to dashboard it shows rpm trim etc but when I go to the Yamaha page the command link is not reading. Is there a new cable needed to interface with that page?


RE: [CA11] GS165 2020 trip Yamaha 300s interface - Chuck - Raymarine - Moderator - 04-14-20 01:45 PM

Welcome to the Raymarine Forum Seadub,

With regard to its use on Raymarine MFDs, the Yamaha app may only be run on MFDs running LightHouse 3 (you have met this requirement) and, accordingly Chapter 13.1 Yamha app overview of the LightHouse 3.11 Advanced Operation Instructions may only be used with Yamaha engine systems which have been interfaced to the marine electronics backbone via Yamaha's NMEA 2000 gateway (6YG-8A2D0-00-00) or CL7 Gauge. I suspect that your engines may currently be interfaced to the system via Raymarine's ECI-100 engine gateway.