[JB] [JB] What gauge is the wind transducer wire - Printable Version +- Raymarine forum (http://forum.raymarine.com) +-- Forum: Raymarine Forums (/forumdisplay.php?fid=1) +--- Forum: Instruments (/forumdisplay.php?fid=117) +--- Thread: [JB] [JB] What gauge is the wind transducer wire (/showthread.php?tid=11347) |
[JB] What gauge is the wind transducer wire - TributeJ42 - 05-19-20 07:49 AM I have an analog masthead wind transducer cable that I need to splice. I will get the marine grade male and female plugs but have two questions: 1. How many wires are in the cable (I have read 5 but only see 4) 2. What gauge is the wire? Thanks! Barry RE: [JB] What gauge is the wind transducer wire - Jules - Raymarine - Moderator - 05-21-20 01:03 AM Hello Barry, I'm assuming that you're connecting these below decks. Connections in the mast will be quite bulky and prone to corrosion no matter what connectors you use. Q-1. How many wires are in the cable (I have read 5 but only see 4) A-1. There are 4 insulated wires and a shield around all of them to eliminate interference so 5 conductors in total. Make sure you get shielded cable! Q-2. What gauge is the wire? A-2. This is not critical, but a flexible wire would be better as it handles acute turns better and I think AWG14 or AWG16 would be enough as there is very little current draw. Something similar would be good. Happy boating and kind regards Jules |