[TG] [TG11] After Update to 3.1142 - Axiom 7 DV fails to boot - Printable Version +- Raymarine forum (http://forum.raymarine.com) +-- Forum: Raymarine Forums (/forumdisplay.php?fid=1) +--- Forum: General Discussions (/forumdisplay.php?fid=2) +--- Thread: [TG] [TG11] After Update to 3.1142 - Axiom 7 DV fails to boot (/showthread.php?tid=11486) |
[TG11] After Update to 3.1142 - Axiom 7 DV fails to boot - schomakr - 05-28-20 02:25 PM Hi -i tried to update my Axiom 7 DV to 3.11.42. When it rebooted - it went to the axiom flash screen - then the lighthouse screen then repeated this loop. Reading on the forums - it was recommended to do a erase / factory reset - which I did. Now to goes from axiom flash screen to lighthouse screen multiple times. Eventually it gets to startup wizard step 1 with english selected. Once here touch screen does not allow selection. After 20 seconds or so - starts all over with axiom splash to lighthouse to startup wizard. What are the next steps? Thanks RE: [TG11] After Update to 3.1142 - Axiom 7 DV fails to boot - Tom - Raymarine - Moderator - 06-05-20 02:15 AM Hello schomakr, I'm sorry to hear that. It's possible that the problem occurring around the time of the upgrade is coincidental, there are some other possible causes for that sort of problem:
If you eliminate what you can of these and still have problems then you should get the display checked by your supplying dealer or Raymarine service centre. Regards, Tom |