+- Raymarine forum (http://forum.raymarine.com)
+-- Forum: Raymarine Forums (/forumdisplay.php?fid=1)
+--- Forum: Fishfinders (/forumdisplay.php?fid=25)
+--- Thread: DSM300 stops reading bottom (/showthread.php?tid=1170)
DSM300 stops reading bottom - OviV - 06-16-16 08:33 AM
I have a DSM300 that has been trouble for as long as I have owned the boat. It would often stop showing bottom even while anchored and I would just turn it off and back on or sometimes turn off the screen that was showing sounder data and back on and it would read again. Lately it has gotten worse. The bottom display will freeze, I will turn off the sounder and back on, it will start displaying again and then freeze again after about 30 seconds. The screens will sometimes report that pings are disabled.
The sounder has good power with its own switch on my panel where I can turn it off and on. It does not appear to be hot when the problems occur but if does seem to happen after it has been running for sometime. I have checked all of the connections and all (power and network) are tight and clean. It is connected via an HS5 switch to 2 c95 screens. Screens and sounder have all been upgraded to the latest firmware.
Any suggestions?
Ovi
RE: DSM300 stops reading bottom - Chuck - Raymarine - Moderator - 06-16-16 10:27 AM
Welcome to the Raymarine Forum Ovi,
It appears that you have performed most of the troubleshooting items identified here. Please review and perform the remaining troubleshooting items. Should the problem persist, then the DSM300 should be sent to Raymarine's Product Repair Center per the referenced FAQ to be bench tested/serviced.
RE: DSM300 stops reading bottom - OviV - 06-16-16 03:40 PM
Thank you for the response Chuck. If I have to send it in, what is the typical turnaround time?
Ovi
RE: DSM300 stops reading bottom - Chuck - Raymarine - Moderator - 06-17-16 09:37 AM
Ovi,
Turn around time is typically about ten business days after we have received the product.