+- Raymarine forum (http://forum.raymarine.com)
+-- Forum: Raymarine Forums (/forumdisplay.php?fid=1)
+--- Forum: Autopilots (/forumdisplay.php?fid=23)
+--- Thread: Hydraulic Pump ID (/showthread.php?tid=1465)
Hydraulic Pump ID - bstreep - 07-25-16 10:48 PM
OK, we got the EV-400 Sail installed this weekend. So much simpler than the old ST! But we need to ID our old pump so we can configure this thing. Can you look at the photos and tell us what we might have? Thanks in advance,
Bill
RE: Hydraulic Pump ID - Chuck - Raymarine - Moderator - 07-26-16 09:24 AM
Bill,
The hydraulic pump and ram do not appear to be manufactured by Raymarine. Are there any identification plates/labels not shown within your photos or possible cubic capacity stamped on the ram?
RE: Hydraulic Pump ID - bstreep - 07-26-16 10:36 AM
Not a single tag on it. This was connected to an ST7000+
Any thoughts as to how to configure this?
Bill
RE: Hydraulic Pump ID - Chuck - Raymarine - Moderator - 07-26-16 10:50 AM
Bill,
Without having any data on the drive, we'll have to attack this from steering information and length/weight of the vessel. Accordingly, please indicate the vessel's length, displacement, and whether it features a hydraulic or mechanical helm.
RE: Hydraulic Pump ID - bstreep - 07-26-16 11:13 AM
OK, Chuck, let's see what we can do.
The boat is a Macintosh/Mcintosh 47
Overall length: 46'11"
Waterline: 40 feet
Modified keel, skeg hung rudder
Design Displacement: 30,500 lbs
Actual weight ~ 38,000 lbs
Steering: Cable
I would guess that the 2 turns, lock to lock, are about 60 degrees, total.
http://sailboatdata.com/viewrecord.asp?class_ID=2810
Thanks again Chuck!
RE: Hydraulic Pump ID - Chuck - Raymarine - Moderator - 07-26-16 12:35 PM
Bill,
The vessel's displacement is slightly the upper end of the specification for Type 3 Linear Drive. Accordingly, you may want to try that Drive Type setting.
RE: Hydraulic Pump ID - bstreep - 07-26-16 07:05 PM
Thanks Chuck! We'll try that and see this weekend.
Bill
RE: Hydraulic Pump ID - Chuck - Raymarine - Moderator - 07-27-16 09:57 AM
You're welcome.