+- Raymarine forum (http://forum.raymarine.com)
+-- Forum: Raymarine Forums (/forumdisplay.php?fid=1)
+--- Forum: Multifunction Displays (/forumdisplay.php?fid=120)
+--- Thread: E120 Volt display on data bar (/showthread.php?tid=1531)
E120 Volt display on data bar - bobsled - 08-03-16 11:43 AM
Hello,
i have two E120s on my boat that are connected to a 4 bank battery system, 1-3 for the three outboards and the 4th or house bank being the one for the electronics of course. I have been unable to find a setting within the E120 that will show the voltage it is receiving from the house bank, does this MFD have the capability to do so? i couldn't find anything in all of the manuals.
RE: E120 Volt display on data bar - Chuck - Raymarine - Moderator - 08-31-16 12:31 PM
Welcome to the Raymarine Forum bobsled,
The E-Series Classic MFDs are not designed to report voltage supplied to the MFDs. When interfaced to a powered and properly terminated SeaTalkng/NMEA 2000 backbone which in turn has been interfaced to a NMEA 2000 engine gateway, these MFDs may report alternator voltage if transmitted by the engine gateway.