Interfacing TackTick Instruments with MFD a97 - Printable Version +- Raymarine forum (http://forum.raymarine.com) +-- Forum: Raymarine Forums (/forumdisplay.php?fid=1) +--- Forum: Multifunction Displays (/forumdisplay.php?fid=120) +--- Thread: Interfacing TackTick Instruments with MFD a97 (/showthread.php?tid=1753) |
Interfacing TackTick Instruments with MFD a97 - nvallettejr12 - 08-30-16 09:43 AM I just recently had a EV-100 Autopilot as well as an a97 MFD installed on my sailboat. I am interested in linking the wireless TackTick interface with the MFD. It have the wind, speed, and depth package. I understand there may be multiple ways of doing this, however, I am unsure of what equipment is required. Does the a97 receive NMEA 0183 V2.30 automatically or does it only receive NMEA 2000 sentences? Any help is greatly appreciated. RE: Interfacing TackTick Instruments with MFD a97 - Chuck - Raymarine - Moderator - 08-30-16 11:20 AM nvallettejr12, The NMEA 0183 OUT terminals of the TackTick Wireless Interface may be interfaced the NMEA 0183 IN2 leads found on the MFD's Power/NMEA 0183/Video Input Cable. The MFD's NMEA 0183 Port 2 would need to be configured to "NMEA 4800". No other settings need be configured. RE: Interfacing TackTick Instruments with MFD a97 - nvallettejr12 - 08-31-16 11:08 AM Thanks Chuck, Where would I find about 10-15 feet of NMEA 0183 cable? Also how do I access the NMEA 0183 Port 2 settings to configure it on the a97? RE: Interfacing TackTick Instruments with MFD a97 - Chuck - Raymarine - Moderator - 08-31-16 01:27 PM nvallettejr12, Commonly available marine grade twisted pair signal cable should be used to extend NMEA 0183 leads of the MFD's Power/NMEA 0183/Video Input Cable. The MFD's NMEA Port 2 is configured via the command sequence HOME->SET-UP->SYSTEM SETTINGS->NMEA SET-UP->NMEA INPUT PORT 2. |