+- Raymarine forum (http://forum.raymarine.com)
+-- Forum: Raymarine Forums (/forumdisplay.php?fid=1)
+--- Forum: Multifunction Displays (/forumdisplay.php?fid=120)
+--- Thread: E127 MFD Shows My Location on Land (/showthread.php?tid=2298)
E127 MFD Shows My Location on Land - N1ml - 12-28-16 10:40 AM
I was out boating Monday and noticed that the MFD indicated that my position was on land. I have dual E127 displays. Usually I have it set up as heads up, with my current position shown as a small boat with a cross superimposed on it. All of a sudden the boat and cross got separated. I powered down and powered up. All was OK and then I got a couple of beeps and a popup came on. I tried to cancel the popup informing me of a waypoint, it cleared and then the problem with my position came up again. My software is V17-17.45. I noted online that I am one revision out of date. This problem has happened before, but then it went away. It came back several times. I am also running Navionics mapping software.
Is there something I should check?
RE: E127 MFD Shows My Location on Land - Chuck - Raymarine - Moderator - 12-29-16 10:05 AM
Welcome to the Raymarine Forum
Please click here to view a FAQ addressing this subject. Should you have any additional questions, then please indicate:
- which device within your system has been selected to provide the system with GPS data, and
- whether the selected GPS sensing device has been afforded an unobstructed view of the skies overhead, and
- what is the GPS HDOP value reported by the system when the reported symptom occurs.