+- Raymarine forum (http://forum.raymarine.com)
+-- Forum: Raymarine Forums (/forumdisplay.php?fid=1)
+--- Forum: Marine Cameras (/forumdisplay.php?fid=121)
+--- Thread: Cam210IP Installation (/showthread.php?tid=2599)
Cam210IP Installation - Trawlerboat - 02-27-17 01:38 PM
I am investigating installing the 210IP Camera into our current system. The system has a HS Network Switch with available RJ45 ports. MFD's are es127 and an eSeries.
Cable Run is about 30 ft.
1. Can I run shielded RJ45 male to Male cable from the HS Network Switch to the Camera?
2. Should I run 16 gauge Red/Black Power Cable?
3. Will the pigtail on the camera connect both the RJ45 and the Power Cable?
4. Should I have a separate power switch for the camera?
Any other recommendations would be appreciated.
Thank You
Barry
RE: Cam210IP Installation - Chuck - Raymarine - Moderator - 03-01-17 04:38 PM
Welcome to the Raymarine Forum Barry,
Q1. Can I run shielded RJ45 male to Male cable from the HS Network Switch to the Camera?
A1. Yes
Q2. Should I run 16 gauge Red/Black Power Cable?
A2. The gauge of cable installed is dependent upon the round trip distance involved. Please click here to view a web page addressing this subject.
Q3. Will the pigtail on the camera connect both the RJ45 and the Power Cable?
A3. Yes. Alternatively, a POE Injector may be installed between the camera and the Network Switch, to instead power the camera via the POE.
Q4. Should I have a separate power switch for the camera?
A4. All products should be powered via a switched power circuit.