+- Raymarine forum (http://forum.raymarine.com)
+-- Forum: Raymarine Forums (/forumdisplay.php?fid=1)
+--- Forum: Instruments (/forumdisplay.php?fid=117)
+--- Thread: Wiring help with installation (/showthread.php?tid=2731)
Wiring help with installation - john sharkey - 03-20-17 01:28 PM
Chuck;
I have attached a wiring schematic of how I installed my new Raymarine products, could you review and let me know if it is properly wired.
I have power to both units, but the i50 is not picking up a depth signal from the transducer.
John Sharkey
RE: Wiring help with installation - Chuck - Raymarine - Moderator - 03-20-17 03:47 PM
Welcome to the Raymarine Forum John,
Your diagram is correct as long as the total spur length is less than or equal to 6m. In order for an i50 Depth/Tridata Instrument to repeat Depth and/or Speed (Temp) data, the instrument must be configured as a Depth Repeater or Speed Repeater respectively. Instructions for configuring the Master / Repeater state may be found within section 6.4 Data master of the i50 Instruments Installation and Operation Instructions.