Axiom RealVision 3D Transducer Installed with Optional Jack-Plate Mount Kit - Printable Version +- Raymarine forum (http://forum.raymarine.com) +-- Forum: Raymarine Forums (/forumdisplay.php?fid=1) +--- Forum: Fishfinders (/forumdisplay.php?fid=25) +--- Thread: Axiom RealVision 3D Transducer Installed with Optional Jack-Plate Mount Kit (/showthread.php?tid=2821)

Axiom RealVision 3D Transducer Installed with Optional Jack-Plate Mount Kit - Jim McGowan - 04-04-17 08:18 AM This is the new Axiom RealVision 3D RV-100 transom mount transducer mounted using the optional Jackplate Mounting Kit (A80480) and Jackplate Spacer Kit (A80482). This particular installation is on the back of the new BassCat Lynx bass boat, which uses a SeaStar Solutions Jackplate. The boat was on display at the 2017 Bassmaster Classic Outdoor Expo, and is one of the first to use this transducer setup. It is a simple and sturdy setup for bassboats, skiffs and other jackplate-equipped shallow water vessels. All of the components are made of rugged stainless steel. The RV-100's normal transom mount kickup bracket and carrier get unbolted from the transducer itself, and the jackplate bracket slides into the same position and gives you a pattern of convenient side-mount holes. Here is an image of the bracket kit alone so you can see the holes better: We also offer a spacer kit that allows you to position the transducer farther outboard in case you have any clearance issues: Here is one more view of the bracket attached to the RV-100: RAYFAQ#