+- Raymarine forum (http://forum.raymarine.com)
+-- Forum: Raymarine Forums (/forumdisplay.php?fid=1)
+--- Forum: Instruments (/forumdisplay.php?fid=117)
+--- Thread: ST50+ Wind factory reset (/showthread.php?tid=299)
ST50+ Wind factory reset - miken6mz - 03-07-16 11:19 AM
Good morning. Last week I successfully repaired my ST50+ Wind (without schematics!); there was a faulty semiconductor on the anemometer board in the masthead transducer and also a faulty transistor in the control head. I want to perform a factory reset and then linearize and calibrate the transducer again. I found the procedure to do the factory reset for an ST60+ Wind in that manual, but I cannot find the factory-reset procedure for the ST50+. Can you help? Thanks in advance.
RE: ST50+ Wind factory reset - Steve - Raymarine - Moderator - 03-09-16 03:47 PM
There is no Reset with the ST50+ product line. You can adjust the alignment, but that is it. The ST50+ wind instrument needed a machine in our service department to reset to board. That is no longer available.