Raymarine forum
Depth to the iTC5 - Printable Version

+- Raymarine forum (http://forum.raymarine.com)
+-- Forum: Raymarine Forums (/forumdisplay.php?fid=1)
+--- Forum: Instruments (/forumdisplay.php?fid=117)
+--- Thread: Depth to the iTC5 (/showthread.php?tid=3415)



Depth to the iTC5 - Sam batterson - 06-23-17 09:46 AM

I wired my DST 800 to the iTC-5 in the following manner: unprotected wire to the shield receptacle, the blue and black wires to their respective colors. Speed and the wind seem to work okay, but the depth still gets a blinking light. I am not in the water so I didn't expect an accurate read, but I am getting no reading at all. Is this common?


RE: Depth to the iTC5 - Chuck - Raymarine - Moderator - 06-23-17 03:06 PM

Welcome to the Raymarine Forum Sam.

The system is behaving normally. One would not typically expect that a low power instrument depth transducer would be capable of sensing any depth when the transducer is out of the water or located in water having a depth which is less than 3' beneath the transducer.