ITC-5 voltage - Printable Version +- Raymarine forum (http://forum.raymarine.com) +-- Forum: Raymarine Forums (/forumdisplay.php?fid=1) +--- Forum: Instruments (/forumdisplay.php?fid=117) +--- Thread: ITC-5 voltage (/showthread.php?tid=3574) |
ITC-5 voltage - Randy - 07-17-17 01:37 PM I have wind, speed and depth transducers connected to ITC-5 converter, connected to I70 instruments and ES plotter. Recently Wind direction indicator stopped reading wind direction change. Indicator on instrument only changes slightly from "stuck "position. I did test of wind transducer and read only 6 volts between red and ground. I supplied 8 volts from separate power supply and wind instrument preformed normally. The 6 volts was read off of the ITC-5 at wind power spade connector. All other instruments are working fine. I read 8 volts at the speed power connection and wondered if I could safely draw wind power from the speed power connection until I was in a position to replace or repair the ITC-5 converter. If indeed thats the problem. Thank you for in advance for your help. Randy RE: ITC-5 voltage - Chuck - Raymarine - Moderator - 07-26-17 03:44 PM Welcome to the Raymarine Forum Randy, Please excuse this late response. Based upon the voltage measurement reported, it appears that there is an issue with the iTC-5 necessitating that it be replaced or sent to Raymarine’s Product Repair Center to be bench checked / serviced. RE: ITC-5 voltage - Randy - 07-27-17 07:41 AM Thanks Chuck. But Can I safely piggy back wind power off of the speed power spade connection on the ITC-5 until I can pull the ITC off the boat for repair. Thank you again for your help. Randy RE: ITC-5 voltage - Chuck - Raymarine - Moderator - 07-27-17 08:54 AM Randy, The iTC-5's Power (red) terminals of both the Wind and Compass transducer terminals are designed to output +8VDC. Accordingly, you may want to try measuring the voltage of the Power terminal of the Compass transducer terminals to determine whether it is outputting +8VDC. If so, then it may be used until such time as the iTC-5 can be serviced. |