+- Raymarine forum (http://forum.raymarine.com)
+-- Forum: Raymarine Forums (/forumdisplay.php?fid=1)
+--- Forum: Instruments (/forumdisplay.php?fid=117)
+--- Thread: [CA] Setting depth offset (/showthread.php?tid=4413)
[CA] Setting depth offset - [email protected] - 12-12-17 02:00 PM
Previously I had an ST-40 instrument and C70 MFD. I would set the offset for depth in the ST-40.
I did not upgrade the depth sensor, but did upgrade to an eS98 MFD with the depth, speed, and wind data connected to the system via an ITC-5. I have a P70 in this system as well.
Is there a way to set the offset of the transducer depth in the eS98 software? I have not found so far . . . perhaps there will be an option in the new Lighthouse software?
I still have the ST-40 and tried to connect it using the ST1 to STNG adapter. It powers the ST-40, but no data is shown. Perhaps there is a way to connect this to the system so to set offset.
Thanks in advance,
Robert
RE: [CA] Setting depth offset - Chuck - Raymarine - Moderator - 12-12-17 02:24 PM
Welcome to the Raymarine Forum Robert,
If an iTC-5 has been installed within a system, then in i70/i70S MFID must also be installed within the system. Depth offset would then be configured within the menus of the i70/i70S MFID. Should the eS98 MFD's transducer port be interfaced to a high CHIRP (conical) / DownVision transducer, then the system would feature multiple depth data sources. In such systems, the MFD's Data Sources feature (HOME->SET-UP->SYSTEM SETTINGS->DATA SOURCES) must be used to specify which source of depth will be used by the Raymarine system.