+- Raymarine forum (http://forum.raymarine.com)
+-- Forum: Raymarine Forums (/forumdisplay.php?fid=1)
+--- Forum: Fishfinders (/forumdisplay.php?fid=25)
+--- Thread: [CA] Axiom transducer selection (/showthread.php?tid=4661)
[CA] Axiom transducer selection - RayJoe46 - 01-30-18 07:21 PM
I would like to purchase a down vision or real vision transducer for my Axiom MFD.
I would like a thru hull transducer and if possible the dimension of the shaft of the new transducers that will work with the Axiom. My Axiom is an Axiom 9 with real vision.
My boat is a 1983 Tiara 31 open.
Thanks,
Joe
[email protected]
RE: [CA] Axiom transducer selection - Chuck - Raymarine - Moderator - 02-02-18 09:55 AM
Welcome to the Raymarine Forum Joe,
The hull's deadrise in the location where the transducer will be installed will need to be measured. A RV-212 transducer pair would be recommended for deadrise angles from 1° to 12°. The RV-220 transducer pair would be recommended for deadrise angles from 13° to 20°. Full dimensional data for these transducers may be found within Chapter 3.7 - Transducer dimensions - RV-2xx of the RV-2xx 3D Bronze Transducer Installation Instructions.