+- Raymarine forum (http://forum.raymarine.com)
+-- Forum: Raymarine Forums (/forumdisplay.php?fid=1)
+--- Forum: Product and Feature Suggestions (/forumdisplay.php?fid=128)
+--- Thread: [CA] Axiom Water Temperature Selection (/showthread.php?tid=4772)
[CA] Axiom Water Temperature Selection - SalishMermaid - 02-13-18 07:47 PM
I have an Axiom 12 with a Airmar ST800 and RV-212 transducers connected. I believe the Temperature function on my ST800 is not working but I am using it for the Speed function. I had hoped to use the RV-212 for the temperature, but I can't find a way to select which transducer pull the temperature from.
When in the RV-212 setup screen it shows the temperature from the RV-212 and it is accurate. The only temperature that will display on the screen is the faulty 104degree temperature I assume from the ST800.
There is a info note on the RV-212 screen that says this is not the system temperature, but I can't figure out how to set it as the system temprature. There is a question mark on the screen, but I tried to click on it and nothing happens. I assumed that it would have opened with some instructions.
Is this something that is in work to be fixed on a later software update or am I just missing how to configure it to pull the temperature from the RV-212?
RE: [CA] Axiom Water Temperature Selection - Chuck - Raymarine - Moderator - 02-14-18 12:16 PM
Welcome to the Raymarine Forum SalishMermaid,
Unfortunately, the Data Sources feature within LightHouse 3 did not include water temperature source selection. LightHouse II will prioritize instrument water temperature sources over those from a fishfinder. A feature request has been submitted to consider adding water temperature to the Data Sources feature within a future LightHouse 3 software update as well as within the software designed for future MFDs.
Please click here more information concerning feature suggestions.
RE: [CA] Axiom Water Temperature Selection - Seadub - 04-07-20 09:26 PM
Hey chuck I have this same issue. My airmar transducer is not showing correct temp but I just bought a rvx-1000 with a80464 transducer. Has the software been updated to select which transducer to pull temp from?
RE: [CA] Axiom Water Temperature Selection - Chuck - Raymarine - Moderator - 04-08-20 07:47 AM
Welcome to the Raymarine Forum Seadub,
While LightHouse 3 software (as of v3.11.42) does not feature temperature data source selection. However instead, within the Fishfinder application page/pane for the 200kHz or 50kHz Channel, select MENU->SETTINGS and then within the Sonar or Transducer tab, you will find option to utilize / not utilize temperature from the transducer.