[CA] Confused about my C120/gps interface.... - Printable Version +- Raymarine forum (http://forum.raymarine.com) +-- Forum: Raymarine Forums (/forumdisplay.php?fid=1) +--- Forum: NAVAIDS (/forumdisplay.php?fid=122) +--- Thread: [CA] Confused about my C120/gps interface.... (/showthread.php?tid=4781) |
[CA] Confused about my C120/gps interface.... - Joe O'D - 02-15-18 12:29 AM Hello all, Please pardon my ignorance here, but I need the benefit of some advice from the lightened among us. I just bought a used C120 mfd with radome and gps antenna from a gentleman who was fortunate enough to be upgrading electronics priot to some major adventure. However, I digress: my problem lies with connecting my gps to the mfd. the unit came with a black cable with a 5 pin connector, the cores of which are bare, red, green, yellow, and black ( I think). The gps antenna came with a fixed white cable, the cores of which are white, brown, green, and yellow. Can I assume I just need to connect the two cables, and plug it into the corresponding socket on the back of the mfd for the gps to work, and if so ( here comes the tricky bit) which cores connect to each other? If it's not that simple, what do I need to do? I know I may be asking the relatively obvious, but I just forked out hard-earned cash for this unit and I don't want to mess it up. Thanks in advance to all those willing to offer help and advice. RE: [CA] Confused about my C120/gps interface.... - Chuck - Raymarine - Moderator - 02-15-18 11:25 AM Welcome to the Raymarine Forum Joe, In order address your question, we're going to need to know the make/model of GPS sensor which you are seeking to interface to the MFD. Should the GPS sensor be branded Raymarine, then please attach a photo of the label affixed to the underside of the GPS sensor to your response to this post. |