+- Raymarine forum (http://forum.raymarine.com)
+-- Forum: Raymarine Forums (/forumdisplay.php?fid=1)
+--- Forum: Product Selection Assistance (/forumdisplay.php?fid=124)
+--- Thread: (DG) Auto pilot course computer compatability (/showthread.php?tid=4906)
(DG) Auto pilot course computer compatability - Paul Erben - 03-05-18 03:24 PM
I have an older Autohelm Auto Pilot (AP) system with a type 300 12v computer that acts up intermittently.
Can I replace it with a SG2 computer?
The rest of my AP system consists of a type 2 hydraulic pump, ST6000/7000 control units and unknown model tiller and compass sensors.
Regards
RE: (DG) Auto pilot course computer compatability - Derek - Raymarine - Moderator - 03-06-18 07:40 AM
Hi Paul Erben
Thank you for your enquiry.
The older version T300 Course computer that you have is the correct version for the T2 Hydraulic drive. The S2G Computer however is limited to T1 Drives only and so will not suit the drive that you have.
You will need to get an S3G variant of the course computer, or an SPX30 variant, the current control unit, rudder position sensor and compass you have willwork with either of these two variants.
The other alternative is to update to the current evolution system, you would need to replace all the components you currently have with the exception of the T2 drive and the rudder position sensor.
This link click here refers to the evolution pilot on our website
regards
RE: (DG) Auto pilot course computer compatability - Paul Erben - 03-06-18 03:22 PM
Your welcome
RE: (DG) Auto pilot course computer compatability - Paul Erben - 03-06-18 03:24 PM
Derek,
Thanks for your response.
Regards
RE: (DG) Auto pilot course computer compatability - Derek - Raymarine - Moderator - 03-07-18 05:56 AM
your welcome