Raymarine forum
[CA] Axiom 7 Surface Install - Printable Version

+- Raymarine forum (http://forum.raymarine.com)
+-- Forum: Raymarine Forums (/forumdisplay.php?fid=1)
+--- Forum: Multifunction Displays (/forumdisplay.php?fid=120)
+--- Thread: [CA] Axiom 7 Surface Install (/showthread.php?tid=5283)

[CA] Axiom 7 Surface Install - Solo_Cam21 - 04-24-18 10:07 PM

Hi Support,

I have an Axiom 7 screen going into my console as a surface install. Would the included back surface cover or the rear mounting brackets be the best option? I currently have the included cover but was curious why there is another type of rear mounting bracket available?

Also would any marine sealant be necessary for between the front of the screen against the console or is the included foam seal all that is needed?

Thank you for your assistance.

RE: [CA] Axiom 7 Surface Install - Chuck - Raymarine - Moderator - 04-26-18 03:02 PM

Welcome to the Raymarine Forum Solo_Cam21,

Please see the diagram below. If installing per option 3 (Surface Mount), then Axiom 7's package should contain all that is needed. Raymarine only recommends using the supplied gaskets to seal MFDs to a helm.

[Image: attachment.php?aid=1685]