+- Raymarine forum (http://forum.raymarine.com)
+-- Forum: Raymarine Forums (/forumdisplay.php?fid=1)
+--- Forum: Instruments (/forumdisplay.php?fid=117)
+--- Thread: (DG) Triducer installation (/showthread.php?tid=5513)
(DG) Triducer installation - mwalsh7 - 05-20-18 03:57 AM
I have just installed the thru hull for my triducer and am little confused by which 0-rings i should have on. I believe it is the DST800V that I have as the housing has the flap that closes over and the insert does not have the ribs that the older model has. However the insert has a black O-ring at the top and the yellow one mentioned in the instructions is in the box. Should I be removing the black o-ring and putting the yellow in its place? See attached picture
RE: (DG) Triducer installation - Derek - Raymarine - Moderator - 05-24-18 06:40 AM
Hi mwalsh7
Thank you for your enquiry.
Yes,you will need to replace the Black O ring with the yellow one, please ensure to use some lubricant - such as biodegradable soap or similar to lubricate both O seals before inserting the insert. Without lubricant the insert will be very stiff and will not seat fully.
Regards
RE: (DG) Triducer installation - stanb - 06-28-18 08:50 AM
Hi,
I ordered the DST800V through amazon.ca (supplied by amazon not a 3rd party) as part of the i70 system kit.
The instructions talk about a yellow o-ring but the one on the transducer was black and the one in the replacement kit for non-valve thru-hulls was also black (and thinner).
I tried phone support but had no luck reaching anyone who could help - I was told by the one person I got hold of not to worry about it just use it as is.
Regards,
Stan
RE: (DG) Triducer installation - Derek - Raymarine - Moderator - 06-29-18 05:02 AM
Hi stanb
The Yellow O-Ring is thicker and when greased will give a tighter seal and is the advice we received from Airmar who supply the transducers.
Best regards
Derek