+- Raymarine forum (http://forum.raymarine.com)
+-- Forum: Raymarine Forums (/forumdisplay.php?fid=1)
+--- Forum: Multifunction Displays (/forumdisplay.php?fid=120)
+--- Thread: [TG] [TG11] Lighthouse 3 Radar Overlay (/showthread.php?tid=6064)
[TG11] Lighthouse 3 Radar Overlay - Doug Brown - 07-11-18 11:19 AM
I need some help with programming radar overlay over the chart. Both chart and radar functions work fine independently as well as on a split screen. I can't seem to find the option or how to overlay them. Your help is greatly appreciated!
RE: [TG11] Lighthouse 3 Radar Overlay - Tom - Raymarine - Moderator - 07-18-18 01:35 AM
Hello Doug,
On the Chart page/app, go to Menu > Settings (gearbox at the bottom) > Layers > Radar toggle (will only appear when a radar is detected on the network.)
The radar needs to be transmitting of course, and if you don't have an autopilot or other source of magnetic heading data then you'll need to enable the setting 'Use radar without heading data' in the Advanced tab. Note that this is off by default because radar overlay from GPS COG is significantly less accurate/reliable than from heading - I personally always recommend using a good-quality source of heading data if using radar overlay.
Regards,
Tom
RE: [TG11] Lighthouse 3 Radar Overlay - Doug Brown - 07-18-18 12:29 PM
Thank you Tom.
We will check it out.
D
RE: [TG11] Lighthouse 3 Radar Overlay - Tom - Raymarine - Moderator - 07-19-18 01:39 AM
No problem.
Tom