Raymarine forum
[TG] Spanning Tree (STP) - Printable Version

+- Raymarine forum (http://forum.raymarine.com)
+-- Forum: Raymarine Forums (/forumdisplay.php?fid=1)
+--- Forum: Multifunction Displays (/forumdisplay.php?fid=120)
+--- Thread: [TG] Spanning Tree (STP) (/showthread.php?tid=6184)



Spanning Tree (STP) - swamplynx - 07-24-18 07:43 AM

Do Raymarine MFD’s support spanning tree (STP)?

I have two MFDs which I’d like to connect to each other directly, but also both to the Ethernet switch (third-party with STP support) with their second Ethernet ports. This creates a redundant physical network, but if the MFDs don’t support STP it could create a loop. I am assuming each Ethernet port on the MFDs is a part of a virtual switch and not an interface (i.e. the MFD only has one IP address, not one for each Ethernet port).

Thanks!


RE: Spanning Tree (STP) - Tom - Raymarine - Moderator - 07-27-18 01:04 AM

Hello swamplynx,

The MFDs do indeed each have a single IP. I don't know about STP support for sure, but very much doubt it - this isn't an intended/designed configuration or connection method, and we don't tend to make lives harder for ourselves by implementing features (and then having to test, support and then regression-test on each new software release) if we're not going to utilise the feature.

Sorry,
Tom