+- Raymarine forum (http://forum.raymarine.com)
+-- Forum: Raymarine Forums (/forumdisplay.php?fid=1)
+--- Forum: Autopilots (/forumdisplay.php?fid=23)
+--- Thread: [DG] [DG11] Smart Pilot LTP13 (/showthread.php?tid=7565)
[DG11] Smart Pilot LTP13 - mcarroll51 - 03-03-19 12:30 PM
From the Smart Pilot Service Manual:
"Rate gyro
1. Using a DVM, measure the voltage at the rate gyro output (LTP13). If the rate gyro is serviceable, the
nominal reading is 2.5 V ± 0.3 V."
Where is LTP13?
RE: [DG11] Smart Pilot LTP13 - Derek - Raymarine - Moderator - 03-04-19 12:09 PM
Hi mcarroll51
The test point is located withinn the SPX course computer and is shown below
regards
Derek
RE: [DG11] Smart Pilot LTP13 - mcarroll51 - 03-04-19 04:14 PM
Thanks. Can you direct me to it on the circuit board?
RE: [DG11] Smart Pilot LTP13 - Derek - Raymarine - Moderator - 03-05-19 04:56 AM
Hi mcarroll51
Troubleshooting/diagnostic/repair information which extends to opening a product's case to perform any specific testing or repairs to the product's circuitry is outside of the scope which is to be supported via Raymarine's Forum.
We are unable to give further details on the forum since this level of repair is supported only through the Raymarine approved dealer network.
Regards
Derek