+- Raymarine forum (http://forum.raymarine.com)
+-- Forum: Raymarine Forums (/forumdisplay.php?fid=1)
+--- Forum: Multifunction Displays (/forumdisplay.php?fid=120)
+--- Thread: [DG] [DG11] A70d software update (/showthread.php?tid=7696)
[DG11] A70d software update - ptempel - 03-19-19 11:30 AM
I want to update the firmware in my A70d plotter.
Put the software on a CF card 16GB
The plotter did not started up.
Pushing the power-button gives some lights on the screen and then goes to black again. Nothing happens.
Please help
Best regards
Peter
RE: [DG11] A70d software update - Derek - Raymarine - Moderator - 03-22-19 05:26 AM
Hi ptempel
Thank you for your enquiry.
The software upgrade on the A70d should be quite straight forward, and it should not be causing the MFD stop powering up.
Please try a full factory reset,
* With the unit turned off press and hold the left hand soft key
* Keep it pressed and turn the unit on
* On screen it will say 'Factory Reset' and count down from 3
* Unit will reset and load into normal operation. This can take a couple of extra minutes than normal.
**Please make sure you back up all Waypoints and Routes etc to a separate Compact Flash Card other than your Cartography Card**
If the unit still will not power up correctly, we recommend the unit be sent to Raymarine’s Product Repair Center to be bench checked / serviced.
Regards
Derek