+- Raymarine forum (http://forum.raymarine.com)
+-- Forum: Raymarine Forums (/forumdisplay.php?fid=1)
+--- Forum: General Discussions (/forumdisplay.php?fid=2)
+--- Thread: [LW] [LW11] No AIS on Axiom 9pro (AIS 700) (/showthread.php?tid=7910)
[LW11] No AIS on Axiom 9pro (AIS 700) - NORDBORG - 04-12-19 12:40 AM
Hi, we have just installed a Raymarine AIS700, connected to an Axion 9 Pro and a RAY60 VHF through NMEA 2000.
The AIS700 sends and recieves data without any problem (When minitoring it on proAIS2).
The problbem is that the Axiom 9 pro does not provide an AIS overlay, so I have no possibility to get the AIS data on the Axiom 9 Pro screen (Navionics+ chart).
What could be a possible solution?
Thank you in advance.
RE: [LW11] No AIS on Axiom 9pro (AIS 700) - Louise - Raymarine - Moderator - 04-12-19 07:30 AM
Dear NORDBORG,
Thank you for your query.
Is the AIS showing on the network?
Home>settings>network> you will see a list of the products on the network - is the AIS700 here?
Have you got the AIS layer turned on?
Chart application>menu>settings>Layers> here you will see AIS layer with a toggle switch - is this on?
If it is off you will not see any AIS targets.
Many Thanks
Louise
RE: [LW11] No AIS on Axiom 9pro (AIS 700) - Glorybax - 03-27-20 02:22 PM
Hi.
I have a similar problem. The AIS 700 won’t show up in the network list on the MFDs, a pair of Axim Pro 12. The AIS shows the green light when powered, goes blue when I switch to silent mode and red when I unplug the gps cable so that unit seem to be working.
To verify the network I plugged in an EV 1 sensor which powers up, shows a green light and pops un on the mfds unit, as a unit showing the heading. That indicates that the network is working I guess.
Only the master mfd is connected to the NMEA 2000 and the second mfd is connected to the master with a network cable. As the EV 1 comes through that should verify that the NMEA 2000 cable is connected to the master mfd.
What did I get wrong?
RE: [LW11] No AIS on Axiom 9pro (AIS 700) - Louise - Raymarine - Moderator - 03-31-20 05:51 AM
Dear Glorybax,
I have responded to this in your other post.
Send in a system diagram to [email protected]
Many Thanks
Louise