+- Raymarine forum (http://forum.raymarine.com)
+-- Forum: Raymarine Forums (/forumdisplay.php?fid=1)
+--- Forum: Autopilots (/forumdisplay.php?fid=23)
+--- Thread: [CA] [CA11] SP-X10 calibration (/showthread.php?tid=8055)
[CA11] SP-X10 calibration - Phillip - 04-27-19 01:54 AM
Hi, I have a used SP-X10 with an ST-6002 control head. I installed it and went through the calibration process (several times). Each time I turn the power off I get a message on the control head "Required Calibrn". I set the boat type to Sail Boat. I also did a "swing" and have a deviation of 9 degrees. Why does it still display Required Calibration?
RE: [CA11] SP-X10 calibration - Chuck - Raymarine - Moderator - 04-29-19 12:31 PM
Welcome to the Raymarine Forum Phillip,
Did you also perform the AutoLearn feature of the SeaTrial calibration (see page 16 of the SPX-10 Set-up and Commissioning Guide? If so and the problem persists, then it would indicate that the autopilot course computer is suffering a memory failure and should be sent to Raymarine’s Product Repair Center to be bench checked / serviced.