+- Raymarine forum (http://forum.raymarine.com)
+-- Forum: Raymarine Forums (/forumdisplay.php?fid=1)
+--- Forum: Autopilots (/forumdisplay.php?fid=23)
+--- Thread: [LW] [LW11] adjust rudder stop angle (/showthread.php?tid=8504)
[LW11] adjust rudder stop angle - [email protected] - 06-09-19 02:21 PM
Hi !
I have just started uo my EV 200 linear system. It seems to be working fine but only tried it in calm conditions.
My rudder stops are a bit to weak for the drive- they bend slightly during the dock side calibration, is it possible to enter the rudder stop angle manually to decrease it a few degrees in order to make it stop sooner? I have a working rudder position sensor, EV-1 ACU 200, Linear drive type 1.
Best Regards
Peter
RE: [LW11] adjust rudder stop angle - Louise - Raymarine - Moderator - 06-11-19 11:00 AM
Dear Peter,
You need to set the rudder limits up on the EV200. You can find the instructions here.
Many Thanks
Louise
RE: [LW11] adjust rudder stop angle - [email protected] - 06-17-19 07:41 AM
Thank you, it went quite easy with your support. You might have linked to a different doc. than the applicable one but i found in the Swedish version.
Best Regards and thanks for the support.
Peter
RE: [LW11] adjust rudder stop angle - Louise - Raymarine - Moderator - 06-20-19 10:51 AM
You are welcome.