+- Raymarine forum (http://forum.raymarine.com)
+-- Forum: Raymarine Forums (/forumdisplay.php?fid=1)
+--- Forum: Multifunction Displays (/forumdisplay.php?fid=120)
+--- Thread: [CA] [CA11] GS125, VHF RAY260 AIS not working (/showthread.php?tid=8698)
[CA11] GS125, VHF RAY260 AIS not working - eddiejaimes - 06-27-19 09:50 AM
good Morning ,
I have a GS125, I recently upgraded the software to the latest LH3 I have a RAY260 VHF radio conected to the network via sea talk. I cant see any of the targets on the chart plotter, Is there anything that i should be looking? I looked in the menu of the vhf and make sure the unit is conected via nma200
RE: [CA11] GS125, VHF RAY260 AIS not working - Chuck - Raymarine - Moderator - 07-02-19 11:05 AM
Welcome to the Raymarine Forum Eddie,
Per our phone conversation, it recommended that you ensure that Ray260's AIS feature has been enabled:
Switching the AIS function on and off
The AIS function on the Ray260 AIS and Ray260E AIS can be switched on or off.
From the main menu:
1. Select CONNECTION.
2. Select AIS.
3. Select ON or OFF as required.
Additionally, with the built-in AIS receiver switched on AIS information can be sent to a connected Raymarine multifunction display using either the NMEA 0183 or SeaTalkng connections.
Note: If using the built-in AIS receiver and outputting over NMEA 0183, ensure that the baud rate is set to high speed: Menu > Connection > Interface > NMEA 0183 > HIGH