+- Raymarine forum (http://forum.raymarine.com)
+-- Forum: Raymarine Forums (/forumdisplay.php?fid=1)
+--- Forum: Multifunction Displays (/forumdisplay.php?fid=120)
+--- Thread: [LW] [LW11] Full offset (/showthread.php?tid=9028)
[LW11] Full offset - Stefan - 07-25-19 01:54 AM
Hi, I updated right now to the latest V3.10.39 for my Axiom 7 MFD.
I go to the setup, View & Motion, but the boat position cant be changed, it stays on “Centre†and is gray. But I want to have “full offset†as it was before the upgrade from V3.9. I have set the chart motion to “Relative motion†and the Chart orientation to “Head-up†as written in the manualk. What is wrong? Pls advice how I get back to the “full offset†as before.
RE: [LW11] Full offset - Louise - Raymarine - Moderator - 08-02-19 05:14 AM
Dear Stefan,
Thank you for your post.
A reason for this would be due to lack of heading data, have you a heading source on the vessel and are you seeing this on the Axiom?
When only COG is available the 'offset' options would also be unavailable when stationary as the MFD does not have any valid data to offset to. When underway these options will become available when a COG becomes available.
Many Thanks
Louise
RE: [LW11] Full offset - Stefan - 08-06-19 04:07 AM
It works now. I understand that the boat has to move, tried to make the setup at the harbour.
RE: [LW11] Full offset - Louise - Raymarine - Moderator - 08-07-19 07:14 AM
No worries.