+- Raymarine forum (http://forum.raymarine.com)
+-- Forum: Raymarine Forums (/forumdisplay.php?fid=1)
+--- Forum: Multifunction Displays (/forumdisplay.php?fid=120)
+--- Thread: [CA] [CA11] Axiom 12 and Axiom 9 not communicating (/showthread.php?tid=9330)
[CA11] Axiom 12 and Axiom 9 not communicating - captrv - 08-20-19 01:54 PM
I have an Axiom 12 Pro and Axiom 9 (display only). Before the last update (week ago) on both units, all was fine. The 12 was set up as the data master prior to update. Now the 9 does not acknowledge the 12 and shows itself as the date master. Also, new waypoints installed did not save to the unit and had to be re-inputted three days in a row. The 12 also got stuck in power up mode a couple of times at start up.
RE: [CA11] Axiom 12 and Axiom 9 not communicating - Chuck - Raymarine - Moderator - 08-23-19 02:34 PM
Welcome to the Raymarine Forum RV,
It is recommended that you verify that each MFD has been updated with LightHouse 3 v3.10.42 or later software. If so, then it is recommended that a Power On Factory Reset operation be performed to each MFD to address the reported issue. It is further recommended that the MFD's settings be manually reconfigured rather then restored from a saved system settings file. Restoring waypoint/route/track data may be done without concern.