[CA] [CA11] Masthead transducer test - Printable Version +- Raymarine forum (http://forum.raymarine.com) +-- Forum: Raymarine Forums (/forumdisplay.php?fid=1) +--- Forum: Instruments (/forumdisplay.php?fid=117) +--- Thread: [CA] [CA11] Masthead transducer test (/showthread.php?tid=9721) |
[CA11] Masthead transducer test - thebarold - 10-12-19 08:43 PM I tried to test my transducer today using a new transducer cable, however I was unable to get 8V across the red and shield from the source wiring inside the boat. (assume shield is the non-insulated wire). If I bring a separate power supply and set it to 8V what current should be supplied to the red and shield? Thank you. RE: [CA11] Masthead transducer test - Chuck - Raymarine - Moderator - 10-14-19 03:46 PM Welcome to the Raymarine Forum thebarold, What voltage level did you measure between the red and shield leads? RE: [CA11] Masthead transducer test - thebarold - 10-23-19 03:10 PM The mast has been un-stepped and I cannot use the transducer on the mast and am trying to test the transducer on a work bench. RE: [CA11] Masthead transducer test - Chuck - Raymarine - Moderator - 10-24-19 02:57 PM thebarold, Please click here to view a FAQ addressing this subject. 8VDC should be applied across the masthead's red and black terminals when testing. |