[LW] [LW11] New SeaTalkng device on SeaTalk1 network

[Owntelemaque]

Hi,

I used to have the ST60+ system installed on my boat:
- ST60+ with its Wind module and depth finder
- ST50 (multi-function display)
- ST4000+ (Auto pilot)

I got struck by lighting and needed to replace the wind module by a i60 that is now SeaTalkng

Now I have:

- ST60+ display with the depth finder
- Wind module i60 with sensor (SeaTalkng)
- ST50 (multi-function display)
- ST4000+

Please, see picture for details of the devices.

I understood easily how to connect the wind sensor on the i60 but can't figure out how to connect the i60 to the rest of the system.
Are they any cables I can buy to connect the SeaTalkng to the SeaTalk1 network? At the moment I can't even plug the power to the i60.

Can you help me please?

Thank you,
Nicolas

[Louise - Raymarine - Moderator]

Dear Nicolas,

You can buy an adaptor cable for this specific purpose, the ST1 (3 pin) to STng spur (female) available in 2 lengths.

A06047 is 400mm
A06073 is 1m

Many Thanks
Louise