Raymarine forum / Raymarine Forums / Autopilots v / [CA] EV-400 Pilot Commissioning

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] EV-400 Pilot Commissioning
03-30-18, 07:37 AM (This post was last modified: 03-30-18 01:37 PM by Chuck - Raymarine - Moderator.)
Post: #1
barberhaulerr Offline
Junior Member
**
 		Posts: 8
Joined: Aug 2017
Reputation: 0
[CA] EV-400 Pilot Commissioning
I just installed an EV-400 pilot on a Defever 48. The EV-400 replaced a Simrad J300/AP21 pilot.
The RPU160 hydraulic pump was retained.
Steering ram capacity is 26.0". Does that indicate that I should select type 3 hydraulic pump as the drive type?
Thank you.
Find all posts by this user
Quote this message in a reply
03-30-18, 02:32 PM
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: [CA] EV-400 Pilot Commissioning
Welcome to the Raymarine Forum barberhaulerr,

As a Type 3 Hydraulic Pump would typically be used with a steering ram having a capacity of 26 cu. in., it would we recommended that the Type 3 Hydraulic Pump drive option be selected when running the Set-up Wizard.
Find all posts by this user
Quote this message in a reply
03-31-18, 09:39 PM
Post: #3
barberhaulerr Offline
Junior Member
**
 		Posts: 8
Joined: Aug 2017
Reputation: 0
RE: [CA] EV-400 Pilot Commissioning
Thank you!
Find all posts by this user
Quote this message in a reply
04-02-18, 01:45 PM
Post: #4
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: [CA] EV-400 Pilot Commissioning
You're welcome.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 2 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication